OPTIMISATION OF UV/H2O2 TREATMENT OF MONOETHANOLAMINE USING THE TAGUCHI METHOD OF EXPERIMENTAL DESIGN
Teks penuh
Gambar
Dokumen terkait
Consequently, a study on the degradation process of MDEA using UV/H 2 O 2 that may possible as pre-treatment of the MDEA waste before biological oxidation was conducted in
This project focuses in development of design process at the conceptual design for automotive fender, determine the most optimum decision on conceptual design by using
The introduction of highly efficient Interior Point Method (IPM) based algorithms and software for convex optimization since the 90s has motivated people to apply convex
This study discusses the application of taguchi method in the optimization of cutting parameter for surface roughness in turning process of mild steel.. The test
The combination of grey relational and fuzzy logic analysis of material removal rate and surface roughness obtained from the Taguchi method reduced from the
The water hyacinth compost was then characterized to determine the humic acid content, as well as the functional groups Determination of optimum conditions on the adsorption of
28 Optimization of the Wire Electric Discharge Machining Process of Nitinol-60 Shape Memory Alloy Using Taguchi-Pareto Design of Experiments, Grey-Wolf Analysis, and Desirability
In case of 7th Days split tensile strength, the optimum proportion is obtained at water powder ratio at P3 0.34%, fly ash % at Q1 0%, steel fibre type at R3 15mm and super plasticizer